or go to the Advance Search

• 
• 
  • Adhesive              >>
    • Selection Guide
      (Solid Concrete)
    • Selection Guide
      (Hollow Block & Drywall)
    • A7 Acrylic Adhesive
    • C6 Fast Curing Epoxy
    • G5 High Strength Epoxy
    • Screens: Nylon & SS
    • Stubby Screens
    • Umbrella Inserts
    • Accessories
    • Working Principles
  • Mechanical           >>
    • Selection Guide
      (Solid Concrete)
    • Selection Guide
      (Hollow Block & Drywall)
    • Trubolt: Wedge Anchor
    • Trubolt+:
      Seismic Wedge Anchor
    • Multi-Set II: Drop-In Anchors
    • Prima: High Expansion Sleeve Anchor
    • Dynabolt: Sleeve Anchor
    • Stud Anchor
    • Redi-Drive: Hammer-Drive Anchors
    • Hammer-Set: Nail-Drive Anchor
    • Poly-Set: Plug Anchor
    • Working Principles
  • Screw Anchors    >>
    • LDT: Large Diameter Tapcon
      Self-Threading Anchor
    • LDT: Large Diameter Tapcon
      with EnvireX coating
    • Boa Coil: Expansion Anchor
    • Tapcon: Self-Tapping Anchor
    • E-Z Ancor: Drywall Anchor
  • New Products      >>
    • Sneak Peak
• 
  • Approvals/Listings
  • Performance/
    Submittal Data (A&E)
  • Suggested Specifications
  • MSDS
  • Installation Instructions
  • Training Materials
• 
  • Electrical Contractor
  • Mechanical Contractor
  • Drywall Contractor
    & Carpenter
  • Acoustical Ceiling Installer
  • Steel Erector & Curtain Wall
  • Concrete & Masonry Contractor
  • Water & Waste Water Treatment
  • Highway & Bridge Contractor
  • General Contractor
  • Material Handling
  • Specialty
• 
  • Product Catalog
  • Sell Sheets
  • Marketing Bulletins
• 
  • Customer Service
  • Technical Support
  • Field Engineer
  • Red Head Sales
  • Comments or Suggestions
  • National Headquarters
  • Human Resources
  • Red Head Partners
•  

	Screen Tubes
	INSTALLATION INSTRUCTIONS 1. Drill proper sized hole, using rotation-only drilling mode. Clean out hole with forced air. Complete hole preparation with use of a brush and repeat cleaning with forced air (leave no dust or slurry). 2. When starting new cartridge or new nozzle, dispense and discard enough adhesive until uniform adhesive mix is achieved. Insert the nozzle into the bottom of the screen and fill screen completely full (use extension tube if needed to reach bottom of screen). 3. Insert the filled screen completely into the hole (subflush). 4. While holding the tab of the screen against the wall, hand insert the selected rod slowly into the screen tube with a slow twisting motion. Pull screen flush to face and coat with adhesive. Wait for appropriate cure time before torquing fixture into place.
Screen Tubes Product Information and Advantanges Installation Instructions / Estimating Tables / Order Information Performance Data

---

ITW Red Head • 2171 Executive Drive • Addison, IL 60101 • 630-350-0370

About Us | Careers | Press Releases | Privacy Policy | Terms and Conditions

copyright © 2009 Illinois Tool Works, Inc.