Redi-Drive   
Anchors—High   
Performance   
Without   
Torquing   

Light-Duty Hammer-Drive Masonry Anchor
SPECIFIED FOR ANCHORAGE INTO CONCRETE, BLOCK AND BRICK
The Redi-Drive is a high performance small diameter one-piece hammer-drive anchor. The anchor holds based on a friction principle—the shank diameter is larger than the drill hole size. Anchors should be installed with carbide tipped hammer drill bits made in accordance to ANSI B212.15-1994

The Redi-Drive is available in four types... mushroom head, pipe-hanging (1/4" & 3/8"), Tie- Wire, and double head forming versions. Anchor performance in solid concrete at one inch embedment shall exceed 400 lbs. allowable tension load and 750 lbs. allowable shear load.

High performance provides superior holding values in concrete and other masonry materials
Fire resistant
Tamper resistant
Standard 3/16" drill hole size—cheaper bit and faster installation
Available in 3/4", 1-1/8", 1-5/8". 2", 2-1/2", and 3" lengths
Most economical steel anchor available
Provides fast, high performance drive-type fastening without torquing or need for special setting equipment

As simple as using a nail— drive into predrilled holes for tremendous holding strength in concrete. Compressive strength is created by forcing a larger diameter fastener into a smaller size hole.The greater the degree of contact the greater the holding power.