or go to the Advance Search

• 
• 
  • Adhesive              >>
    • Selection Guide
      (Solid Concrete)
    • Selection Guide
      (Hollow Block & Drywall)
    • A7 Acrylic Adhesive
    • C6 Fast Curing Epoxy
    • G5 High Strength Epoxy
    • Screens: Nylon & SS
    • Stubby Screens
    • Umbrella Inserts
    • Accessories
    • Working Principles
  • Mechanical           >>
    • Selection Guide
      (Solid Concrete)
    • Selection Guide
      (Hollow Block & Drywall)
    • Trubolt: Wedge Anchor
    • Trubolt+:
      Seismic Wedge Anchor
    • Multi-Set II: Drop-In Anchors
    • Prima: High Expansion Sleeve Anchor
    • Dynabolt: Sleeve Anchor
    • Stud Anchor
    • Redi-Drive: Hammer-Drive Anchors
    • Hammer-Set: Nail-Drive Anchor
    • Poly-Set: Plug Anchor
    • Working Principles
  • Screw Anchors    >>
    • LDT: Large Diameter Tapcon
      Self-Threading Anchor
    • LDT: Large Diameter Tapcon
      with EnvireX coating
    • Boa Coil: Expansion Anchor
    • Tapcon: Self-Tapping Anchor
    • E-Z Ancor: Drywall Anchor
  • New Products      >>
    • Sneak Peak
• 
  • Approvals/Listings
  • Performance/
    Submittal Data (A&E)
  • Suggested Specifications
  • MSDS
  • Installation Instructions
  • Training Materials
• 
  • Electrical Contractor
  • Mechanical Contractor
  • Drywall Contractor
    & Carpenter
  • Acoustical Ceiling Installer
  • Steel Erector & Curtain Wall
  • Concrete & Masonry Contractor
  • Water & Waste Water Treatment
  • Highway & Bridge Contractor
  • General Contractor
  • Material Handling
  • Specialty
• 
  • Product Catalog
  • Sell Sheets
  • Marketing Bulletins
• 
  • Customer Service
  • Technical Support
  • Field Engineer
  • Red Head Sales
  • Comments or Suggestions
  • National Headquarters
  • Human Resources
  • Red Head Partners
•  

Redi-Drive Anchors

Product Information Suggested/Ordering Information Performance Data Approval Listings REDI-DRIVE INSTALLATION STEPS 1. Drill a 3/16" diameter hole (1/4" for 3/8" pipe drive) at a minimum depth (see chart) and clean hole. 2. Insert anchor through material to be fastened (insert tie-wire or pipe version Redi-Drive Anchors into drilled holes) and drive anchor with a 3-lb. hammer until the head is flush with surface or desired embedment. 3. Anchor is now set. REDI-TIE-DRIVE INSTALLATION STEPS 1. Drill 3/16" diameter hole in concrete. 2. Hammer in flat side of Redi-Drive 1-1/4". 3. The Redi-Drive is set. Tie acoustical or electrical drop wire to open hole. REDI-PIPE-DRIVE INSTALLATION STEPS 1. Drill 3/16" diameter hole for 1/4" anchor (1/4" diameter hole for 3/8" anchor). 2. Hammer in anchor 1-1/4" for 1/4" anchor (1-3/4" for 3/8" anchor). 3. The Redi-Drive is set. Run 1/4" or 3/8" threaded rod or bolt into anchor.   Download PDF of Installation Instructions Redi-Drive Masonry Anchor Product Information Selection and Order Information Performance Data Approvals and Listing

---