or go to the Advance Search

• 
• 
  • Adhesive              >>
    • Selection Guide
      (Solid Concrete)
    • Selection Guide
      (Hollow Block & Drywall)
    • A7 Acrylic Adhesive
    • C6 Fast Curing Epoxy
    • G5 High Strength Epoxy
    • Screens: Nylon & SS
    • Stubby Screens
    • Umbrella Inserts
    • Accessories
    • Working Principles
  • Mechanical           >>
    • Selection Guide
      (Solid Concrete)
    • Selection Guide
      (Hollow Block & Drywall)
    • Trubolt: Wedge Anchor
    • Trubolt+:
      Seismic Wedge Anchor
    • Multi-Set II: Drop-In Anchors
    • Prima: High Expansion Sleeve Anchor
    • Dynabolt: Sleeve Anchor
    • Stud Anchor
    • Redi-Drive: Hammer-Drive Anchors
    • Hammer-Set: Nail-Drive Anchor
    • Poly-Set: Plug Anchor
    • Working Principles
  • Screw Anchors    >>
    • LDT: Large Diameter Tapcon
      Self-Threading Anchor
    • LDT: Large Diameter Tapcon
      with EnvireX coating
    • Boa Coil: Expansion Anchor
    • Tapcon: Self-Tapping Anchor
    • E-Z Ancor: Drywall Anchor
  • New Products      >>
    • Sneak Peak
• 
  • Approvals/Listings
  • Performance/
    Submittal Data (A&E)
  • Suggested Specifications
  • MSDS
  • Installation Instructions
  • Training Materials
• 
  • Electrical Contractor
  • Mechanical Contractor
  • Drywall Contractor
    & Carpenter
  • Acoustical Ceiling Installer
  • Steel Erector & Curtain Wall
  • Concrete & Masonry Contractor
  • Water & Waste Water Treatment
  • Highway & Bridge Contractor
  • General Contractor
  • Material Handling
  • Specialty
• 
  • Product Catalog
  • Sell Sheets
  • Marketing Bulletins
• 
  • Customer Service
  • Technical Support
  • Field Engineer
  • Red Head Sales
  • Comments or Suggestions
  • National Headquarters
  • Human Resources
  • Red Head Partners
•  

Poly-Set Anchors

Product Information Installation Instructions Suggested/Ordering Information Approval Listings SUGGESTED SPECIFICATIONS For Solid Concrete For Hollow Material 1. Drill hole at least 1/4" deeper than anchor length and insert anchor until flange is flush. 1. Drill hole and insert anchor until flange is flush. 2. Fasten fixture by inserting sheet metal screw through fixture and into anchor. 2. Fasten fixture by inserting sheet metal screw through fixture and into anchor. 3. Tighten screw. 3. Expand anchor after screw head is against fixture, tighten screw the number of additional turns indicated on the chart below.         Poly-Set Anchor Product Information Selection and Order Information Installation Instructions

---