header

or go to the Advance Search
QuickMenu Save Document
INSTALLATION STEPS

To set anchor flush with surface:

1. Drill hole to required embedment (see Table).

  
2. Clean hole with pressurized air.  
3. Drive anchor flush with surface of concrete .  

4. Expand anchor with setting tool provided (see chart). Anchor is properly expanded when shoulder of setting tool is flush with top of anchor.

  
 

To set anchor below surface:
Drill hole deeper than anchor length. Thread bolt into anchor. Hammer anchor into hole until bolt head is at desired depth. Remove bolt and set anchor with setting tool.

 
 

APPLICATIONS

Pumps and heavy piping are common applications for larger diameter Multi-Set Drop-In Anchors.  
Cable tray and strut suspended from concrete ceilings are ideal Multi-Set applications. In post-tension or hollow-core slabs use the RX-38  

The Multi-Set Anchor is the standard for pipe-hanging. The RM version has a retainer lip to keep all anchors flush at the surface, keeping all your threaded rod the same length.  
FEATURES

(A) Expander Slots—allow for easy setting and superior performance

(B) Cone Insert—that expands the anchor when driven with setting tool and hammer

(C) Body—available in zinc-plated steel, 18-8 stainless steel, and 316 stainless steel

(D) Easy Depth Inspection—keeps threaded rod drop lengths consistent

(E) Retainer Lip—to keep anchor flush with surface

APPROVALS / LISTINGS

Meets or exceeds U.S. Government G.S.A. Specification A-A-55614 Type 1
(Formerly GSA: FF-S-325 Group VIII)

Underwriters Laboratories

Factory Mutual

City of Los Angeles – #RR2748

California State Fire Marshal

Caltrans
ITW Red Head • 2171 Executive Drive • Addison, IL 60101 • 630-350-0370
copyright © 2010 Illinois Tool Works, Inc.