A7 10 fl. oz. Cartridges—
with Nozzle

The A7 formulation that has proven it’s performance in prominent NFL football stadiums and countless miles of American roadways is now available to you in a convenient 10 ounce size.

	35 minute cure time at 60°F
	All weather formula
	Rods insert easily in both horizontal and vertical applications
	No cartridge heating required in cold temperatures
	Fully cured below 0°F
	Consistent mix ratio
	Single formula for hollow or solid base materials
	No drip or sag formula cleans up easily
	Works in damp and underwater applications

INSTALLATION STEPS

1	Drill proper sized hole. Clean out hole from bottom with forced air. Complete hole preparation with use of a brush and repeat cleaning with forced air (leave no dust or slurry).
2	When starting new cartridge or nozzle, dispense and discard enough adhesive until uniform dark grey color is achieved. Insert the nozzle into the bottom of the hole and fill to 1/2 the hole depth.
3	Insert the selected rod slowly by hand into the bottom of the hole with a slow twisting motion. This insures the adhesive fills voids and crevices uniformly.
4	See A7 Cure Time Charts for set-up time. After the recommended cure time is met, install and tighten fixture into place.